材料致密化
White paper

Optimizing HIP and printing parameters for EBM Ti-6Al-4V

An investigation of HIP parameters for EBM Ti-6Al-4V has been performed by Arcam AB and Quintus Technologies AB with the aim to maximize the strength of the HIP:ed material.
Optimizing HIP and printing parameters for EBM Ti-6Al-4V

A lower HIP temperature of 800 °C and a higher pressure of 200 MPa gives the highest strength and is also enough to eliminate all internal defects. By printing material with intentionally induced porosity combined with an optimized HIP cycle the highest strength can be obtained.

Share:

Related content

No data was found

This site is registered on wpml.org as a development site.